One of the advantages of VoIP is that voice and Internet services are delivered over the same local loop access circuit using the Internet Protocol (IP).

A T1 local access connection to the Internet that can be configured to carry either 24 digitized data channels or one aggregated concatenated data channel at a rate of 1.544 Megabits Per Second (Mbps) that is connected via a T1 Wan Interface Card (WIC), Channel Service Unit / Data Service Unit (CSU/DSU), and Internet router.

Many VoIP service providers guarantee that phone calls will not travel over the public Internet, but are converted and transmitted over the traditional telephone network directly from the VoIP provider's private Internet network that usually adheres to a defined Quality of Service (QoS).

Representative Telecommunication Services: We offer VoIP PBX, IP PBX, US termination, SIP gateway, VoIP gateway, data and Internet T1 (DS1) lines (1.5 Mbps bi-directional transfer upload and download rate), fractional T1 (DS1) circuits (256 Kbps to 1,024 Kbps), bonded (load balanced) T-1 (DS1) lines (3 Mbps to 12 Mbps), T3 (DS3) lines (6 Mbps to 45 Mbps), point-to-point private lines, Virtual Private Networks (VPNs), MPLS (Multi Protocol Label Switching), wide area network (WAN) configurations, inbound and outbound call center services, IP PBX and Hosted VoIP solutions, dynamic and channelized integrated T1 (DS1) lines, Primary Rate ISDN (PRI) service, etc.

Telephone System Hardware and Solutions: With VARSearch(tm), you can search real-time for telephone system installers and dealers in every local market across the United States. These dealers in your local area can find great deals on VoIP PBX systems, IP PBX systems, Hosted VoIP systems, Managed VoIP Services, and other PBX systems including Cisco, Nortel, Allworx, and Fonality. We specialize in US termination, hosted VoIP, and SIP gateways. Call us at (888) 255-5859.

MPLS is a standardized data switching technology that optimizes network traffic flow and eases management of data networks. MPLS carves specific paths data packets that are identified by a label that saves the time needed for a router to look up the address to the next node in order to forward the packet. MPLS works with the Internet Protocol (IP), Asynchronous Transport Mode (ATM), and frame relay network protocols. MPLS allows most packets to be forwarded at the layer 2 (switching) level rather than at the layer 3 (routing) level and makes it easy to manage quality of service (QoS).

Ethernet is the most widely-used data network protocol today. Standardized as IEEE 802.3, the Ethernet protocol is used for local area networks (LANs) at the Layer 1 (Physical Layer) and Layer 2 (Data Link Layer) of the OSI networking model.

Digital Subscriber Line Service (DSL) has become a very popular Internet access service. This is because DSL uses the existing copper pairs that already exist between most customer premise offices and the local phone company central office (CO). A DSL connection is set up between a DSL modem at the customer premise and a DSL access multiplexer, or DSLAM, at the phone company central office. Both voice and data can be run across the same DSL connection by using a filter to separate voice traffic from Internet traffic.

You can compare MPLS to Frame Relay and ATM technologies.

If you are looking for high-quality, up-to-date information in a simple, easy-to-use format, click on the banner below and you will be taken to the Telecom Links web site where you are always just a mouse click away from information about the telecommunication services you are looking for.

Layer 2 MPLS VPNs (L2VPNs) are similar to Frame Relay, Asynchronous Transfer Mode, or point-to-point Wide Area Networks (WANs).